Tro ubl eshooting and tips
User and/or supervisor SmartCard lost
Cause
Troubleshooting
User and/or supervisor SmartCard lost ► If you have lost your user SmartCard, you
can continue to work with the supervisor
SmartCard.
► If you have lost the supervisor SmartC ard,
you can also continue working, but you no
longer have all rights and cannot initialize
another supervisor SmartCard.
Acoustic warning
Acous ticwa rningsErrors
Cause
Troubleshooting
A beep sounds every few seconds.
The battery is almost dead.
► Charge the battery.
Error messages on the screen
Errormessageso
nthescreen
Errors
This section describes the error messages generat ed by the BIOS Setup. Error messages displayed
by the operating system o r programs a re described in the documentation for the se programs.
If the error message appears repeatedly despite troubleshooting measures,
contact the place of purchase or our custom er service center.
Error message/cause Troubleshooting
CMOS Battery Bad
If the error message occurs repeate dly, the
back-up battery in the notebook is dead.
► Contact your sales outlet or our customer
service center.
System CMOS checksum bad - Default configuration
used
The system confi gurat ion info rmation is
incorrect.
► Switch the notebook off.
► Switch t he notebook on.
► Press th e function key
F2
to access the
BIOS Setup.
► In the BIOS Setup, select the Exit menu.
► Select the entry Load Setup Defaults.
► Select OK and press the Enter k ey.
Extended memory failed at offset: xxxx Failin g Bits:
zzzz zzzz
When testing the exte nded memory. an error
has resulted at the address xxxx.
► Check
whether the additional memory
modul
e has been inserted correctly.
Failure Fix ed Disk n
The settings of the hard disk drive are incorrect.
► Sta
rt the BIOS Se tup (Primary Master
sub
menu) and select the correct settings.
Fujitsu 85
To Next Page
Loading...
