Furuno FEA-2100 - Page 417

Alarms •
••
• 401
Alarm number 2459: STEERING PARAMETER ERROR /7
------------------------------
TRACKPILOT PARAMETER HAS
AN ERROR IN ITS CONTENTS.
CHECK AGAIN INSTALLATION PARA-
METERS OF ECDIS.
Alarm number 2480: TRACK PILOT RECEIVE ERROR /1
------------------------------
ECDIS CANNOT RECEIVE ANY DATA
FROM TRACKPILOT. TO QUIT ALARM
CHANGE "MAIN STEERING"-SELEC-
TOR TO ANY OTHER POSITION THAN
AUTOP. CHECK AND VERIFY TRACK
PILOT OPERATION BEFORE NEW TRY
Alarm number 2488: INTEGRATED STEERING LOST /2
------------------------------
CONNECTION TO THE TRACKPILOT
HAS BEEN LOST WHILE THE SYSTEM
PERFORMED ONE OF THE
INTEGRATED STEERING MODES:
- GOTO TRACK
- GOTO WAYPOINT
- PROGRAM TRACK TURN
CURRENT STEERING MODE CANNOT
CONTINUE
CHECK NEW STEERING SITUATION
Alarm number 3000: PARAM CHANGE DISABLED /3
------------------------------
INSTALLATION PARAMETERS CAN BE
CHANGED ONLY IF THE ROUTE
STEERING IS NOT ON AND THE
KALMAN FILTER IS NOT USED.
CHECK THE SITUATION AND TRY
AGAIN.
Alarm number 4000: NO SENSOR PARAMETERS /2
------------------------------
SENSOR PARAMETER FILES ARE
MISSING.
LOAD INSTALLATION PARAMETERS
OF ECDIS. IF REQUIRED USE
BACKUP COPY OF PARAMETERS.
Alarm number 4001: B-ADAPTER ERROR /1/8
------------------------------
B-ADAPTER DOES NOT OPERATE
DUE TO A SYSTEM FAULT.
SWITCH OFF MAIN CIRCUIT BREA-
KER AND THEN ON AGAIN.
CALL SERVICE IF FAILURE STILL
EXISTS.
Alarm number 4005: GYRO ERROR /3
------------------------------
GYRO1 DATA IS NOT RECEIVED
CORRECTLY.
USE 'INITIAL SETTINGS' MENU
TO SET GYRO AGAIN.
IF FAILURE STILL EXISTS, USE
'SENSORS' SPEED/POSITION PAGE
TO SELECT VALID SENSORS.