11. HOW TO MONITOR ROUTES
11-11
11.8.4 Instant track details
You can see the location and alert type found in an instant track by clicking the [De-
tails] button on the [Instant Track] pop-up window.
Note: If the Status is not [OK], an alert (alarm or warning priority, depending on set-
ting) appears in the Alert box.
11.8.5 How to monitor, stop monitoring an instant track
How to monitor an instant track
If the route check results is "OK", click the [Monitor] button on the [Planning] page in
the [Instant Track] dialog box to start monitoring the instant track route. Click the but-
ton before the time remaining counts to zero, otherwise the instant track will be can-
celed, followed by the message "Instant track is expiration." After the [Monitor] button
is clicked the [Monitoring] page is opened. The [Monitoring] page shows the name of
the instant track and the instant track mode.
The vessel follows the instant track route in the same method as a monitored route,
which is grayed out to indicate it is inactive. For the instant track route connected to a
monitored route, the previous instant track route is also grayed out to show it is inac-
tive. Any additional instant track routes are erased.
Click [Monitor]
button
To Next Page
Loading...
