How to fix for TZTBB Furuno Marine Equipment when picture is not displayed properly?
If the picture is not displayed properly on your TZTBB Furuno Marine Equipment, try turning the power off and on. If the issue persists, contact your dealer for further assistance.
Why echoes do not appear on Furuno GPS?
If marks and characters appear on your Furuno GPS but echoes do not, check that the antenna cable is fastened.
What to do if marks and characters appear, but no picture appears on Furuno Marine Equipment?
If marks and characters appear on your Furuno Marine Equipment but no picture is visible, check that the transducer cable is connected.
How to enable ship track plotting on Furuno GPS?
If the track of your ship is not being plotted on your Furuno GPS, check that the track is turned on. You can also select the [Overlay] - [Tracks] menu from the RotoKey menu.
Why Furuno GPS radar goes into stand-by after selecting [Tx Radar]?
If, after selecting [Tx Radar] on your Furuno GPS, the radar goes into stand-by, this indicates that the overload protection has activated. To restore normal operation, turn off all equipment in the TZT network, wait a few seconds, and then turn everything back on.
What to do if Furuno GPS TZTBB picture is not displayed properly?
If the picture on your Furuno GPS (TZTBB) is not displayed properly, try turning the power off and on. If the problem continues, contact your dealer.
Why is position not fixed on Furuno Marine Equipment?
If your Furuno Marine Equipment position is not fixed, check that the antenna connector is fastened and that the navigator is correctly connected.
What to do if there is no response when a key is pressed on Furuno Marine Equipment?
If there is no response when a key is pressed on your Furuno Marine Equipment, turn the power off and on. If the problem persists, the key may be damaged; contact your dealer for instructions.
What to do if the picture is not updated or the picture freezes on Furuno Marine Equipment?
If the picture on your Furuno Marine Equipment is not updating or freezes, check the antenna cable. If the picture freezes, try turning the power off and then on again.
How to fix Furuno Marine Equipment when you can not turn on the power?
If your Furuno Marine Equipment won't power on, try these steps: * Check for a blown fuse.* Ensure the power connector is securely fastened.* Inspect the power cable connector for any signs of corrosion.* Look for any damage to the power cable itself.* Verify that the battery provides the correct voltage output.
General| Resolution | 1280 x 800 pixels |
|---|---|
| Display Type | LCD |
| Brightness | 1000 cd/m² |
| Touchscreen | Yes |
| Waterproof Rating | IP56 |
| Operating Temperature | -15°C to +55°C |
| Power Supply | 12-24 VDC |
| Weight | 3.5 kg |
| Display Size | 14.1 inches |
To Next Page
