DRIVE LINE
3-39
CHECK
1. Remove inspection plug and make sure that
the oil is topped off.
2. If insufficient, add oil through the inspection plug
hole until it is full to the brim.
CAUTION
The added oil should be of the same grade and
viscosity as the oil originally placed in the dif-
ferential gears.
3. Install the inspection plug.
REPLACEMENT
1. Remove inspection plug and drain plug to
let the oil flow out.
Note: Oil removal is quicker if performed soon after
the vehicle has been stopped and while the
oil is still hot.
2. The drain plug is fitted with a magnet. Wipe off
any metal particles sticking to the magnet and
install the drain plug.
3. Add oil through the inspection plug hole until it
reaches the bottom of the hole.
4. Install the inspection plug.
Tightening torque 98 to 115 Nm (10 to 12 kgfm)
WARNING
The gear oil is extremely hot immediately
after the vehicle has been operated. Take care
to avoid being scalded when draining hot oil.
Give the oil time to cool before draining it.
Tightening torque 98 to 120 Nm (10 to 12 kgfm)
Tightening torque 98 to 120 Nm (10 to 12 kgfm)
75655
FUSO ASCENT-ALEJANDRO CANTO
To Next Page
Loading...