STEERING SYSTEM
3-51
12. If there is any abnormal noise or a fluid level
fluctuation, there is likely still some air trapped in
the power steering system. Turn the steering
wheel several times to raise the fluid tempera-
ture to approximately 60 to 80°C.
13. Stop the engine and wait for approximately five
minutes.
14. Lower the front wheels and turn the steering
wheel several times. If there is no noise or fluid
level fluctuation, the bleeding of the power steer-
ing system is completed.
15. Repeat starting and stopping the engine several
times to remove small air bubbles left in the
power steering oil tank.
16. If air bubbles are not removed completely, drive
the vehicle for a while, then check for abnormal
noise and oil level fluctuation.
17. When bleeding is finished, check that fluid in the
power steering oil tank is within the specified
level range. Also check pipe and hose connec-
tions for fluid leaks.
37. STEERING SHAFT
Recommended lubricant:
Wheel bearing grease
NLGI No. 2 (Li soap)
1. Remove all dust and dirt from the grease fittings
before using it.
2. Apply grease to grease nipple.
38. STEERING DRAG LINK
Recommended lubricant:
Wheel bearing grease
NLGI No. 2 (Li soap)
1. Remove all dust and dirt from the grease fittings
before using it.
2. Apply grease to grease nipple.
Greasing intervals
Every 5,000 km (3,000 miles)
NVI: 5,000 km (3,000 miles)
Greasing intervals
Every 5,000 km
(3,000 miles)
75656
FUSO ASCENT-ALEJANDRO CANTO
To Next Page
Loading...