ENGINE
3-3
1. ENGINE OIL
The first engine oil replacement during the run-in
period should be performed at the first 5,000 km
(3,000 miles).
CAUTION
Replace the engine oil earlier if the engine is fre-
quently used at high speeds or under high load-
ing.
Performance, life, and startability of the engine
depend to a large degree on the engine oil. Always
use oil of the specified grade and viscosity.
The proper engine oil viscosity numbers for various
atmospheric temperature ranges are shown in the
diagram.
Recommended lubricant:
Engine oil
CAUTION
Engine oil with an API classification of CC can-
not be used. Be sure to use engine oil with a
classification of CD or higher.
Quantity required:
Inspection
intervals
At the time of pre-operational
check
Replacement
intervals
Every 10,000 km (6,000 miles)
Classification
Viscosity
Atmospheric
temperature
SAE viscosity
number
API CD, CD/SF, CE,
CE/SF, CF-4 or JASO
classification DH-1
Below 0°C 10W–30
–15 – 15°C 20W–20
–5 – 40°C 30
Above 30°C 40
Oil pan Oil filter
Approx. 8 Approx. 1 liter
00733
FUSO ASCENT-ALEJANDRO CANTO
To Next Page
Loading...