FUTABA 32MZ-WC User Manual

13
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Toggleswitch
VZLWFKHVFDQEHDVVLJQHGWRHDFKIXQFWLRQ
• SA : 3 positions; Alternate; Short lever
• SB : 3 positions; Alternate; Long lever
• SC : 3 positions; Alternate; Long lever
• SD : 3 positions; Alternate; Short lever
• SE : 3 positions; Alternate; Short lever
• SF : 2 positions; Alternate; Long lever
• SG : 3 positions; Alternate; Short lever
• SH : 2 positions; Momentary; Long lever
<RXFDQFKRRVHWKH6ZLWFKDQGWKH2Q2IISRVLWLRQLQWKH
6ZLWFK6HOHFWLRQPHQXRI\RXUPL[
Whenyouchangeswitches(SE,SF,SG,SH):
To relocate switches;
1. Make sure your transmitter is off, and remove the
side rubber cover.
2. Use the driver to turn the screw counter-clockwise
on the switch block and detach the block.
Remove the screw holding the switch block. Pull
the switch block remove.
3. Disconnect the connectors of switches you want to
change.
4. Use the attached jig (inside stylus) to turn the
face nuts counterclockwise, this will detach the
switches.
6(
6*
6)
6+
6$
6'
6%
6&
Alternate2 positions Momentary3 positions
6HOIUHWXUQ
5. To re-attach, use the face nuts to attach switches
from other positions or optional switches to the
switch block.
6. Connect your connectors.
7. Insert the switch block so reconnect the connectors
WKDWLWÀWVFRUUHFWO\LQWRWKHERG\RIWKHWUDQVPLWWHU
and use the driver to tighten the screws.
5HPRYHIURP
WKLVSRLQW

FUTABA 32MZ-WC Specifications

General

Brand	FUTABA
Model	32MZ-WC
Category	Remote Control
Language	English