FUTABA 32MZ-WC User Manual

22
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
BatteryCharging
1. Turn off the transmitter power.
2. Connect the power plug of the AC
adapter to an AC outlet.
*Don't connect AC plug to the T32MZ-WC
without connecting with an AC outlet.
3. Open the back lid of the transmitter and
insert the plug of the AC adapter into the
CHG port.
4. The charging monitor of the transmitter
lights red.
*In the case LCD screen will come on for
several seconds and then go off. It may
take several seconds for charging to start
after the AC adapter is connected.
5. When the battery is fully charged the
charge monitor will light off. Remove the
charge plug and AC adaptor.
*After using the AC adapter always
disconnect the power cord from the AC
outlet.
*The time to charge a completely
discharged battery pack is approximately
4 hours. However, the actual charging
time may vary depending on temperature
and state of the battery.
*If the battery is improperly installed or is
faulty, the charging monitor will not light
and the battery will not charge.
Chargingmonitor
Upside
ChargingRED
OFF Fullcharge
Connect
ACfirst.
ConnecttheACadapter
Choose the conversion
connector according to your
AC socket.
DANGER
TheLT1F6600Blithium-polymerbatteryisfortheT32MZ-WCtrans-
mitteronly.Donotuseitwithotherdevices.
AlwaysusetheincludedACadaptertochargethebattery.The
chargingcircuitisbuiltintotheT32MZ-WC.
WARNING
Thetransmitterbatterycannotbechargedwiththereceivercharger.
Converselythereceiverbatterycannotbechargedwiththetransmitter
charger.

FUTABA 32MZ-WC Specifications

General

Brand	FUTABA
Model	32MZ-WC
Category	Remote Control
Language	English