FUTABA 32MZ-WC User Manual

61
＜
System Menu
＞
+(/,&237(5
$,53/$1(*/,'(5
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
2SHUDWLRQGLUHFWLRQUHYHUVDOPHWKRG
7RXFKWKHVHWWLQJEXWWRQFRUUHVSRQGLQJWRWKH+:
+DUGZDUH\RXZDQWWRUHYHUVH
5HYHUVHWKH+:E\WRXFKLQJ><HV@:KHQ\RX
ZDQWWRVWRSRSHUDWLRQWRXFK>1R@
>1RUPDO@1RUPDORSHUDWLRQGLUHFWLRQ
>5HYHUVH@5HYHUVHVWKHRSHUDWLRQGLUHFWLRQ
+:6HWWLQJ
6WLFNVZLWFKWULPOHYHUDQGNQRERSHUDWLRQGLUHFWLRQ
UHYHUVDO+DUGZDUHUHYHUVH6WLFNUHVSRQVHDQG
K\VWHUHVLVDGMXVWPHQW6WLFN6HWWLQJ&DOLEUDWLRQ6WLFN
PRGHFKDQJH
This function is for adjusting the sticks, switches, and
trim characteristics. It is not unless necessary.
+:5HYHUVH
This function reverses the operation signal of the sticks,
switches, trimmer levers, and knobs.
Note: This setting reverses the actual operation signal,
but does not change the display of the indicators
on the display. Use the Normal mode as long
as there is no special reason to use the Reverse
mode.
6WLFN6HWWLQJ
This function sets the servo response and hysteresis for
stick operation for each condition. The control feeling of
the stick can be adjusted to match the aerobatics.
ŏ7RXFKWKH>+:6HWWLQJ@EXWWRQDWWKH6\VWHP0HQXWR
FDOOWKHVHWXSVFUHHQVKRZQEHORZ
ŏ5HWXUQWR6\VWHP0HQX
3RZHUVZLWFK
The power switch long press time when turning off the
power can be selected from 1 second and 4 seconds.
&DOLEUDWLRQ
Usually, this calibration is unnecessary.
Please perform this calibration, only if a change at the
center of a stick should arise after prolonged use.
6WLFN0RGH
Change the stick mode in the software.
ŏ7RXFKWKH>+:5HYHUVH@EXWWRQDWWKH+:6HWWLQJ
0HQXWRFDOOWKHVHWXSVFUHHQVKRZQEHORZ
ŏ5HWXUQWR+:6HWWLQJ0HQX

FUTABA 32MZ-WC Specifications

General

Brand	FUTABA
Model	32MZ-WC
Category	Remote Control
Language	English