185
＜
Model Menu (Helicopter)
＞
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
+(/,&237(5
7KURWWOH+ROG
This function sets the throttle cut position during an auto
rotation dive. The throttle position can also be set to an
idling position separate from the throttle cut position.
6HWWLQJRIWKHVHWZRSRVLWLRQVFDQEHVHOHFWHGE\VZLWFK
This allows use for switching during training.
Example of use
ŏ 6LQFH 7KURWWOH +ROG KDV WZR PRGHV &XW DQG
,GOH LW LV FRQYHQLHQW WR XVH LW LQ WKH ,GOH PRGH
GXULQJ WUDLQLQJ DQG LQ WKH &XW PRGH ZKHQ
VWRSSLQJWKH HQJLQH
Note: When throttle hold is set to ON in the normal
condition, throttle hold acts and the throttle servo is
deactivated. Always set throttle hold to ON in the hold
condition.
ŏ 5HWXUQ WR 0RGHO 0HQX
ŏ 7RXFK WKH >7KURWWOH +ROG@ EXWWRQ LQ WKH 0RGHO
0HQX WR FDOO WKH VHWXS VFUHHQ VKRZQ EHORZ
ŏ6HW WR WKH HQJLQH VWRS SRVLWLRQ
ŏ6HOHFW WKH 6: WR EH XVHG
ŏ6HW WR WKH LGOLQJ SRVLWLRQ
Setting method
ŏ 2SHUDWLRQ PRGH VHOHFWLRQ
Manual mode: 7KH WKURWWOH KROG IXQFWLRQ LV RSHUDWHG E\
switch operation only.
Auto mode: 7KH WKURWWOH KROG IXQFWLRQ RSHUDWLRQ LV OLQNHG
to the throttle stick position.
Auto position setting: :KHQ WKH $XWR PRGH ZDV
VHOHFWHG WKH WKURWWOH SRVLWLRQ DXWR SRVLWLRQ FDQ EH
VHOHFWHG 0RYH WKH WKURWWOH VWLFN WR WKH SRVLWLRQ \RX ZDQW
WR VHW DQG WRXFK WKH DXWR SRVLWLRQ EXWWRQ
ŏ +ROG SRVLWLRQ DGMXVWPHQW
Throttle Hold (Cut) VHWV WKH WKURWWOH FXW SRVLWLRQ $GMXVW LW
so that the carburetor is full open.
Throttle Hold (Idle): 0DNH WKLV DGMXVWPHQW WR PDLQWDLQ
LGOLQJ IRU WUDLQLQJ $GMXVWPHQWV FDQ EH PDGH EDVHG RQ
the throttle curve idle position.
ŏ 7KH WKURWWOH VHUYR RSHUDWLQJ VSHHG FDQ EH DGMXVWHG
6SHHG
ŏ 7KH +ROG VZLWFK FDQ EH XVHG WR FKDQJH EHWZHHQ WKH
7KURWWOH FXW RU 7UDLQLQJ IXQFWLRQ
Operation precautions
WARNING
When starting the engine, confirm that the idle up
condition and throttle hold condition are [OFF].
To Next Page
Loading...
Need help?
General
