FUTABA 32MZ-WC - RUD Expert (Rudder Gyro Expert Setting); (3) CNT. DlIn: Control delay in; (4) CNT. DlOut: Control delay out; (5) ANG: Pirouette speed

214
＜
Model Menu (Helicopter)
＞
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
+(/,&237(5
RUDExpert（RudderGyroExpertSetting）
RUDExpert（RudderGyroExpertSetting）
(3) CNT. DlIn: Control delay in
Thisparametersetsthedelayasyoumovethestickfromneutraltoward
leftorright.Largervaluesresultinasoftertailrotorfeeloffcenter.This
parametermustbeadjustedindividuallyforLEFTandRIGHTtailrotor
commands.Followthesesameprocedurestoadjustthetailrotorfeelin
theoppositedirection.
[Settingmethod]
MovethetransmitterRudderstickrightorleftinthedirectionyouwant
toset.Touchthegreenbuttontoenterthesettingmodeandsetthede
-
layamount.Dothesamefortheotherside.
Settingranges:0~20  nInitialvalue:15  n
(4) CNT. DlOut: Control delay out
Thisparametersetsthedelaywhenthestickisreturnedbacktothe
neutralposition.Thisparameterisusefulto tunehowaggressivelythe
tailrotorstopsfollowingapirouette.Thehigherthevalue,thesofterthe
stop.Thisparametermustbeadjustedindividually forLEFTandRIGHT
tailrotorcommands.Thesettingmethodisthesameas"CNT.DlIn",so
pleaserefertotheinformationabove.
Settingranges:0~20  nInitialvalue:12  n
(5) ANG: Pirouette speed
Thisparameteradjuststhemaximumpirouettespeedofthetailrotor
thatthegyrowillallowat100%dualrate.
Settingranges:100~999  dInitialvalue:=720  d,