Home screen
Menu screen Racing menu screen
Start
Warning display
If the power switch is
turned on while the
engine cut switch is on,
an audible alarm will be
heard. Immediately set
the engine cut switch to
OF F.
Engine cut ON/OFF is indicated
on the home screen for a few
seconds.
It is displayed in the home
screen, when the engine cut is
ON.
101
Function
Engine Cut
Engine Cut
When the switch is pressed, the throttle servo will move to the preset position without re-
gard to the throttle trigger position. This is convenient when used to cut the engine of boats,
etc. (The switch select function. See page 69)
(Preparation)
- Use the switch select function to the "Switch
select". (page 69)
When the switch is not set "A switch is not
assigned" is displayed. Tap [Switch select] to
display the switch selection screen and set the
switch.
Engine Cut function adjustment
When trigger ratio (page 62) is set to 100: 0, the brake side function will not operate.
The preset position set here is the linkage reference. Set the linkage so that the carbure-
tor is fully closed in the preset adjustment range and the engine stops. Full throttle posi-
tion is set by “advance” of the end point function. Adjust the idling position with throttle
trim.
When trigger ratio was set to 100:0
1M23N32602_7PX_E.indb 101 2017/08/02 14:17:29
To Next Page
Loading...
