Sensor
Change Slot
This procedure changes the slot number of one registered sensor. Connect the sensor as
shown in the gure (page 166), and change slot number.
This function is set when using multiple telemetry sensors of the same type.
1
(Change)
Tap the [Change slot]. The sensor details screen is displayed. Tap the [Read]. The confirma-
tion screen will be displayed. To execute, tap [Yes] to hear an electronic sound and finish
reading. To cancel, select [No] and touch it. If "Reading succeeded" appears and the current
sensor information is displayed.
2
(Number setting)
Tap the value button of the [Start slot #].
Value input buttons appear on the screen.
Use the [+] and [-] buttons to set the start
slot number.
3
Tap the [Write]. When "Writing succeeded"
message is displayed, the number change
is completed.
Sensor slot change
Setting button
Setting with the [+] and [-] but-
tons.
4
When finished, return to the Sensor screen by pressing the HOME button.
1M23N32602_7PX_E.indb 167 2017/08/02 14:17:44
To Next Page
Loading...
