Home screen
Menu screen
Menu-2
Menu-1
Linkage menu
Channel Limiter
Adjust button
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Position
-100~0~+100
Initial value: 0
For S-FHSS (analog) system,
1 to 7 channels are displayed.
75
Function
Channel setting
Channel setting
This function assigns steering or throttle to any channel. You can operate steering and throt-
tle on other channels, and operate other channels in the same way as steering and throttle.
1
(Channel setup)
Tap the channel you want to set, and the
[Steering], [Throttle] setting screen will be
displayed. Tap on [Steering] or [Throttle] set
for that channel and select it. To cancel, tap
[Close].
How to select steering / throttle
2
(position setting of protection channel)
If there is no switch, trim/dial etc. To oper-
ate the auxiliary channel, you can set the
position here.
Tap the rate display part of the channel you
want to adjust. Value input buttons appear
on the channel setting menu screen. Use
the [+] or [-] button to adjust the position.
3
When fi nished, return to the Linkage menu screen by pressing the HOME button.
1M23N32602_7PX_E.indb 75 2017/08/02 14:17:22
To Next Page
Loading...
