Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Mixing amount (Rudder to Flap)
-100~+0~+100
Initial value: +100
Mixing amount (Flap to Rudder)
-100~+0~+100
Initial value: -100
126
Function
Tilt Mixing
3
(Flap rate check and adjustment)
Select the "Flap" by (JOG) button up or down operation, and
adjust the fl aps by [+] or [-] operation.
4
(Rudder to Flap mixing amount adjustment)
Tap the value button of the "Rudder to Flap", Value input but-
tons appear on the screen, and use the [+] and [-] buttons to
adjust the mixing amount.
“+” :Operate in same direction as steering
“-” :Operate in opposite direction of steering
5
(Flap to Rudder mixing amount adjustment)
Tap the value button of the "Flap to Rudder", Value input but-
tons appear on the screen, and use the [+] and [-] buttons to
adjust the mixing amount.
“+” :Operate in same direction as auxiliary channel
“-” :Operate in opposite direction of auxiliary channel
2
(Channel setup)
The channel list screen used for the gain steering channel is displayed. Tap the auxiliary
channel that connected the gain steering channel.
- When all channels are in use, a screen saying "No assignable channel" is displayed, please turn off other mixing
and make an unused channel. You can check the mixing used on the channel setting screen (page 75).
For S-FHSS (analog)
system, 1 to 7 chan-
nels are displayed.
If there is no assignable
channel, tap [Close]. Turn
off other mixing and make
assignable channels.
6
When fi nished, return to the Mixing menu screen by pressing the HOME button twice.
The mixing rate amount can be controlled with digital dial or digital trim, using the dial
select function.(page 66)
Dial / Trim Setting
1M23N32602_7PX_E.indb 126 2017/08/02 14:17:33
To Next Page
Loading...
