FUTABA 7PX - Page 132

Alarm time
OFF, 1 ~ 99 minutes
Initial value: 5 minutes
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Pre-alarm time
OFF, ON
Initial value: OFF
- Tap (ON) / (OFF).
Grip vibrator type (pattern)
Inhibit(Off), Type1,2,3
Initial value: Inhibit
- Tap (ON) / (OFF).
Navi alarm time (NAVI)
OFF, 1 ~ 99 seconds
Initial value: 3 seconds
Start / Stop
Status display
Timer reset
133
Function
Brake Mixing
(Preparation)
Select the "Lap navigate timer
"
from the timer type list and tap.
1
(Alarm time setting)
Tap the value button of the "Alarm time".
Value input buttons appear on the screen.
use the [+] and [-] buttons to set the time
amount.
Tap [Vibrate] and select the vibration pat-
tern of the alarm from 3 types of patterns
and disable (OFF).
(Pre-alarm setting)
Tap (ON) or (OFF) of pre-alarm and select
ON / OFF.
(Lap navigation time setting)
Tap the value button of the "Lap navi". Value input buttons
appear on the screen. use the [+] and [-] buttons to set the
time amount.
2
(Timer start / navigation restart operation)
When the switch ("Timer start") assigned
by switch select function is pressed, the
timer starts.
- Linking only start to the throttle trigger
Tap [OFF] of the trigger to display [Ready]
and wait for the trigger operation. When
you operate the trigger to the forward side,
the timer starts. Stop is the same as when
starting with a switch.
When your own lap time is less than the target time and the
lap counts overlap, the lap navigation alarm timing is too big.
The alarm timing can be corrected by pressing the switch
("Timer start") during measurement.
3
(Timer stop / reset operation)
Press the switch ("Timer reset") set by the
Switch setting function, or tap [Reset] on
the screen. The timer stops.
With the timer stopped, press the switch
("Timer reset") set by the Switch setting
function, or tap [Reset] on the screen. The
timer is reset with the beeping sound.
Using the lap navigate timer
1M23N32602_7PX_E.indb 133 2017/08/02 14:17:35