S.Bus Servo
(Preparation)
- Connect the T7PX and S.BUS or S.BUS2 servo in accordance with the connection dia-
gram shown on page 135.
- Connect the battery to a non-high voltage(HV) support S.BUS/S.BUS2 servo.
1
Turn power on the transmitter. "S.Bus servo" menu is displayed referring to the map of
page135.
2
(S.BUS/S.BUS2 servo read)
Execute this function to read the connected servo type and the data currently set at the
servo. Tap the
[
Read]. The
confirmation screen will be
displayed. To execute, tap
[Yes] to hear an electronic
sound and finish setting. To
cancel, select [No] and touch
it.
-"Reading succeeded" is displayed
on the screen and the servo’s ID
cord and currently set contents are
read.
- If "Failed" is displayed on the screen, communication with the servo is not being performed normally.
Check the T7PX and servo connection to servo and repeat [Read]. (Connect the battery to a non-high volt-
age(HV) support servo.)
3
(Writing to S.BUS/S.BUS2)
Execute this function to write the setting data to
servo. See pages 138 to139 for the setting data
contents.Tap the [Write]. The confirmation screen
will be displayed. To execute, tap [Yes] to hear an
electronic sound and finish setting. To cancel, se-
lect [No] and touch it.
-"Writing succeeded" is displayed on the screen and the setting
data is written to servo.
- If "Failed" is displayed on the screen, communication with the
servo is not being performed normally. Check the T7PX and servo connection to servo and repeat [Write]. (Connect
the battery to a non-high voltage(HV) support servo.)
4
(Initialization)
Write the factory set servo setting data to the con-
nected servo. Tap the [Reset]. The confirmation
screen will be displayed. To execute, tap [Yes] to
hear an electronic sound and finish setting. To can-
cel, select [No] and touch it.
-"Writing succeeded" is displayed on the screen and the setting
data is written to servo.
- If "Failed" is displayed on the screen, communication with the
servo is not being performed normally. Check the T7PX and
servo connection to servo and repeat "Write". (Connect the
battery to a non-high voltage(HV) support servo.)
Using the S.Bus servo function
1M23N32602_7PX_E.indb 136 2017/08/02 14:17:36
To Next Page
Loading...
