Telemetry
1
(Limit adjustment)
Tap the "
" [
Limit] or "
" [
Limit]. Value input buttons appear on
the screen.
Use the [+] or [-] button to adjust the limit voltage.
2
(Alarm and vibrator function setup)
Tap the "
" /
"
"
[Alarm] type and select [Inhibit], [Buzzer]or
[Voice].
"Inhibit":No audible alarm/ "Buzzer":Audible alarm/ "Voice":Voice alarm
Tap the "
" /
"
"
[Vibrator] type and select [Inhibit], [Type 1],
[Type 2], or [Type 3].
"Inhibit" :No active vibration
"Type1" :Continuous vibration
"Type2" :Intermittent vibration for a long time
"Tyoe3" :Intermittent vibration for a short time
3
(Speech function setup)
Tap the "Voice" (ON) or (OFF) to select ON / OFF.
"OFF" :No voice guide
"ON" :Information loaded by voice
4
When finished, return to the Telemetry screen by pressing the HOME button.
Alarm and Vibrator function setup
Setting
- Tap alarm type.
Inhibit/ Buzzer/ Voice
Setting
- Tap Vibrator type.
TInhibit/ Type 1/ Type 2/ Type 3
*The voice guide loading inter-
val is set by sensor menu.
1
(reset operation)
Since either the distance / speed screen can be used, tap [Reference
position setting]. The distance is reset. After that, the distance from
the point where resetting is done is displayed until tapping [Reference
position setting] again.
It takes a while for GPS to be measured after turning on the power. Please wait until the LED of
the GPS sensor turns on green without moving the car body. If the distance display does not
stabilize even after the green LED lights up, or if you set a new reference value for the place
where the car body moved, reset the reference position.
How to set the reference position
1M23N32602_7PX_E.indb 161 2017/08/02 14:17:43
To Next Page
Loading...
