Calibration
(Preparation)
Tap the [Trigger]. The neutral correction screen appears.
1
(Throttle neutral adjustment)
After lightly pulling the throttle trigger to the forward and
brake, tap the [Neutral] in the state in which the trigger is not
touched. If neutral correction is OK, the end point correction
screen appears. If not within the correction range, the end
point correction screen will not appear.
2
(Throttle trigger travel adjustment)
In the end point correction screen (figure at the right) state,
lightly operate the trigger to the full forward and full brake side
and tap the [End point]. If end point correction is OK, the dis-
play returns to the adjuster screen. If not within the correction
range, the display will not return to the adjuster screen. In this
case, return to the system menu by pressing the HOME but-
ton. When operation cannot be ended normally even when
correction is repeated, and cannot be ended normally, contact
the Futaba Service Center.
Throttle adjustment
3
When finished, return to the System menu screen by pressing the HOME button.
1M23N32602_7PX_E.indb 185 2017/08/02 14:17:49
To Next Page
Loading...
