FUTABA 7PX - Page 97

Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
* Throttle trigger position
Servo travel
Trigger point
Reverse direction
Neutral
Normal
direction
High
Trigger point
Trigger point
98
Function
Traction control
Trigger point
5~ 95
Initial value: 30
6
("Trigger point" setup)
Tap the value button of the [Trigger point]. Value input buttons
appear on the screen. Use the [+] and [-] buttons to adjust
the operation point.
- Sets the throttle trigger position at which the traction control function is
performed. The number is the % display with the full brake position made
100.
Tap [Normal] or [Reverse] to set the operating range.
"Normal": High range from the trigger point to the operating range.
"Reverse": Operating range from neutral to trigger point.
7
When finished, return to the Racing menu screen by pressing the HOME button.
Use PS1 to 6 to switch the traction control function ON/OFF.
See the switch select function. (page 69)
Switch setting
The throttle return amount, delay amount and cycle speed can be controlled with digital
trim DT1~DT6 or digital dial DL1 etc. with the dial select function. (page66)
Dial / Trim Setting
1M23N32602_7PX_E.indb 98 2017/08/02 14:17:28