FutureLogic Gen2 Universal PSA-66-ST2RU - Appendix D Schematics; Schematics Introduction for Technicians; Schematics Copyright and Proprietary Notice

To Next Page

To Previous Page

Operators and Technicians Manual

MNL-000032 REV.D

Appendix D Schematics

The schematics included in this appendix are provided solely for use by technicians who service

the GEN2 Universal printer. This information is provided AS IS and without warranty, expressed

or implied.

Note: The information contained in the following schematics is copyrighted information and is

the exclusive intellectual property of FutureLogic, Incorporated. All rights are reserved. No

transfer or grant of rights is created by the publication of this information.

Main Page

Table of Contents3
Manual Overview5
Introduction5
Intended Audience5
Applicability5
Conventions Used in this Document5
Product Overview6
Introduction6
Warranty Information6
Operator Interface7
Introduction7
Operator Indicators and Controls7
Figure 3-1 Operator Indicators and Controls7
Keypad Status Light8
Bezel Operation8
Printer Sensor Functions8
Table 3-1 Keypad Leds Status Reporting Printer Condition8
Table 3-2 Bezel Display Status8
Table 3-3 Sensors8
Printer Errors9
Loading Paper9
Table 3-4 Errors and Error Descriptions9
Feeding Paper10
Figure 3-2 Load a Paper Stack10
Figure 3-3 Feed Paper into Paper Loading Slot10
Performing a Self Test11
Clearing a Paper Jam11
Figure 3-4 Sample Configuration Ticket11
Figure 3-5 Remove the Paper11
Cleaning the Print Head12
Figure 3-6 Open the Lid12
Figure 3-7 Clear the Paper Jam12
Printer Service13
Introduction13
Figure 4-1 Ground Screw and Copper Grounding Clips Location13
Removing the Printer14
Figure 4-2 Disconnect the Coiled Cable Connector14
Figure 4-3 Slide the Printer until It Locks14
Figure 4-4 Remove the Paper15
Figure 4-5 Push Release Bar15
Ports and Cables16
Introduction16
Front Bezel Port16
Figure 5-1 Front Bezel LED Control Port16
Table 5-1 Front Bezel LED Control Port Pin-Outs16
RS232/USB Interface Cable17
Figure 5-2 RS232/USB Interface Cable17
Figure 5-3 RS232/USB Interface Cable, Auxiliary Communications18
Table 5-2 Base Port Cable Pin-Outs18
Table 5-3 RS232 Power/Comm Port Pin-Outs18
Table 5-4 USB Port (Series A) Pin-Outs18
Table 5-5 Bezel LED Control Port Pin-Outs18
RS232 Evaluation Cable19
Figure 5-4 RS232 Evaluation Cable19
Table 5-6 Evaluation Cable Bezel Port Pin-Outs19
GDS Adaptor Cable20
Figure 5-5 GDS Adaptor Cable20
Table 5-7 Evaluation Cable 14 Pin Base Port Pin-Outs20
Table 5-8 Evaluation Cable DB9 RS232 Port Pin-Outs20
Table 5-9 GDS Adaptor Cable Connectors20
Firmware Upload Port21
Figure 5-6 Firmware Upload Port21
Table 5-10 GDS Adaptor Cable Assembly21
Appendix A Technical Specifications22
Appendix B Paper Specifications24
Figure B-1 Ticket Dimensional Specification24
Appendix C Part Numbers - Printer/Spares25
Appendix D Schematics29
Appendix E Regulatory & Compliance35
Index36

FutureLogic Gen2 Universal PSA-66-ST2RU - Appendix D Schematics; Schematics Introduction for Technicians; Schematics Copyright and Proprietary Notice

Table of Contents

Related product manuals