Operators and Technicians Manual
2006 – 2013 FutureLogic, Incorporated. All Rights Reserved. MNL Page ii 04/29/2013
MNL-000032 REV.D
List of Figures
Figure 3-1 Operator Indicators and Controls ...................................................................... 3
Figure 3-2 Load a Paper Stack........................................................................................... 6
Figure 3-3 Feed Paper into Paper Loading Slot ................................................................... 6
Figure 3-4 Sample Configuration Ticket ............................................................................. 7
Figure 3-5 Remove the Paper ............................................................................................. 7
Figure 3-6 Open the Lid .................................................................................................... 8
Figure 3-7 Clear the Paper Jam ......................................................................................... 8
Figure 4-1 Ground Screw and Copper Grounding Clips Location ........................................ 9
Figure 4-2 Disconnect the Coiled Cable Connector ........................................................... 10
Figure 4-3 Slide the Printer until It Locks ........................................................................ 10
Figure 4-4 Remove the Paper ........................................................................................... 11
Figure 4-5 Push Release Bar ........................................................................................... 11
Figure 5-1 Front Bezel LED Control Port .......................................................................... 12
Figure 5-2 RS232/USB Interface Cable ........................................................................... 13
Figure 5-3 RS232/USB Interface Cable, Auxiliary Communications ................................. 14
Figure 5-4 RS232 Evaluation Cable ................................................................................. 15
Figure 5-5 GDS Adaptor Cable ........................................................................................ 16
Figure 5-6 Firmware Upload Port .................................................................................... 17
Figure B-1 Ticket Dimensional Specification .................................................................... 20
List of Tables
Table 3-1 Keypad LEDs Status Reporting Printer Condition .............................................. 4
Table 3-2 Bezel Display Status ......................................................................................... 4
Table 3-3 Sensors ............................................................................................................ 4
Table 3-4 Errors and Error Descriptions .......................................................................... 5
Table 5-1 Front Bezel LED Control Port Pin-outs ............................................................ 12
Table 5-2 Base Port Cable Pin-outs ................................................................................ 14
Table 5-3 RS232 Power/COMM Port Pin-outs ................................................................. 14
Table 5-4 USB Port (Series A) Pin-outs ........................................................................... 14
Table 5-5 Bezel LED Control Port Pin-outs ..................................................................... 14
Table 5-6 Evaluation Cable Bezel Port Pin-outs .............................................................. 15
Table 5-7 Evaluation Cable 14 pin Base Port Pin-outs .................................................... 16
Table 5-8 Evaluation Cable DB9 RS232 Port Pin-outs..................................................... 16
Table 5-9 GDS Adaptor Cable Connectors ...................................................................... 16
Table 5-10 GDS Adaptor Cable Assembly ......................................................................... 17
To Next Page
Loading...
