WARNING
•
During cleaning a radar sensor with a
high-pressure cleaner, clean it gently in
snatches and the nozzle shall be at least
30 cm away from the sensor.
•
If water drops are attached to the
surface of a radar sensor, the sensitivity
of the sensor will reduce. Wiping off
them can restore the sensitivity of the
radar.
•
The surface of some materials cannot
reflect the signal from the radar sensor,
so that the radar sensor cannot detect
such materials or people wearing the
clothing made of such materials.
•
Noise sources outside the car may
interfere with the radar sensor, making it
impossible to detect any target.
•
The radar sensor is a precision
component, which shall not be removed
& refitted and repaired without
authorization. The company does not
assume any responsibility for the
damage caused by unauthorized
removal & refitting and repair.
5.5.2 Reverse image system *
The reverse image system can film at an wide
angle up to 130° and display a wide-range image
behind the car on the AV system display so as to
help the driver to observe complex road conditions
behin
d the car and improve the safety of
reversing.
On and off
In case of the engine start/stop button set to the
"ON" position, the reverse image system
automatically starts to operate if the gearshift lever
is moved to the "R" position. In this case, the AV
system display begins to show the image behind
the car and displays the dynamic trajectory in the
reverse image.
If the gearshift lever is move out of the "R"
position, the reverse image system automatically
stops operating and the AV system exits from the
reverse image.
WARNING
The reverse image system cannot be
substituted for the driver to observing the
surrounding environment. The driver shall
focus on safely reversing according to the
practical conditions.
5. Driving Guide
To Next Page
Loading...
