–
Lift up the wiper arm, press the lock button
①, and slide the wiper blade ②
the arrowed direction to remove it.
– Install the new wiper blade into the wiper arm
in reverse steps. It is installed in place when a
“click” sound is heard.
–
Gently put the wiper arm back on the
windshield.
– Switch the engine start/stop
button to the
"ON" position to let the wiper arm
automatically return in place.
If replacing wiper blades is required, it is
recommended to go to the GAC Motor authorized
shop for replacement.
NOTE
• When lifting up the wiper arm, please grasp
the wiper arm with hands, rather than grasp
the soft wiper blade.
• New wiper blades with the same length and
specifications as the previous ones must be
used.
• Be careful when lowering the wiper arm to
prevent it from falling and hitting the
windshield instantly.
•
The status of the wiper blades must be
checked regularly, and the wiper blades
must be replaced as specified. Damaged
wiper blades must be replaced in time.
• Excessively worn or dirty wiper blades are
very easy to scratch the windshield, and
will affe
ct the field of vision when used,
reducing driving safety.
6.4.5 Brake fluid
Function of brake fluid
Brake fluid is used to transmit power in the
hydraulic brake system of the car.
The brake fluid is water-absorbent. It continuously
absorbs moisture in t
he surrounding air during
use. If the brake fluid stays in the system for too
long and absorbs too much moisture, air
resistance will generate in the system pipeline
during braking, reducing the braking effect and
impairing driving safety; it may even caus
complete failure of the brake system, resulting in
accidents. Therefore, be sure to go to the GAC
Motor authorized shop to check the brake fluid
level or change the brake fluid according to the
period specified in the Warranty Manual.
NOTE
Specifications of brake fluid: DOT4.
6. In-service Maintenance
To Next Page
