–
When installing the A/C filter, install it
according to the upward mark of the A/C filter.
6.6 Replacing bulb
Instructions for replacing bulbs
When replacing bulbs, be careful not to touch the
bulb glass with fingers. Otherwise, the heat of the
bulb will evaporate the grease on the bulb from
fingerprints and condense it on the b
reducing the illuminance of the lamp.
After replacing bulbs, be sure to check the working
status of lamps, and go to the GAC Motor
authorized shop to check the beam status in time.
NOTE
• Lamps for the car include halogen and LED
types. If the LED bulb is damaged, please
go to the GAC Motor authorized shop for
replacement.
•
The removal and refitting methods of the
left and right bulbs are basically the same.
Here only the removal and refitting
methods of halogen bulbs on one side are
described.
NOTE
Damaged bulbs must be replaced with new
ones with the same specifications. For the bulb
specifications of this car, => see page 259.
WARNING
If unfamiliar with the operation process, safe
operation specifications and tool operation
methods, do not replace bulbs yourself.
•
Turn off all lamps before replacing
bulbs, and wait for bulbs till they are
cool before replacement.
•
Pay attention to the sharp parts on the
combination lamp housing in the engine
compartment during operation, and be
c
areful not to scratch hands when
replacing bulbs.
6. In-service Maintenance
To Next Page
