Add coolant
After checking the coolant level, if required, add
coolant following the steps below:
–
Wrap the expansion tank cap with a thick
cloth and unscrew it counterclockwise.
–
Add coolant between the upper limit mark
"MAX" and the lower limit mark "MIN".
– Tighten the expansion tank cap clockwise.
NOTE
• When the engine is not cooled, the cooling
system is under high pressure. Do not open
the expansion tank cap, otherwise the
emerging coolant will cause scald.
• Coolant can only be added after the engine
has cooled down. The coolant level after
filling must not exceed the upper limit mark
"MAX". Otherwise, when the engine starts
and the cooling system is under high
pressure, coolant will overflow.
• Only add fresh coolant.
WARNING
• It is forbidden to mix coolant that is not
approved by our company into the
original coolant.
• In case of emergency, if other coolant is
used or pure water is added, go to the
GAC Motor authorized shop to clean the
cooling system and change the coolant
in time.
• If the coolant consumption is too much
or too fast, there may be a leak in the
cooling
system. Please go to the GAC
Motor authorized shop for inspection in
time.
•
Coolant must be contained in the
original container, and kept out of
children's contact to avoid poisoning
due to accidental ingestion.
6. In-service Maintenance
To Next Page
Loading...
