–
If the intelligent active lock function is
activated and the key is taken away from the
car within 2 m, the indicator lamp of the
intelligent remote control key will flash
continuously until the doors are locked.
NOTE
•
This function can be activated or
deactivated by setting the AV system
“System Settings → Body Accessories →
Lock/Unlock → Intelligent Active Lock (Car
Settings → Intelligent Body → Intelligent
Active Lock)”.
• If the intelligent active lock is successful,
the turn signal lamps will flash once and the
horn will sound once.
•
If one of the doors is ajar, there will be a
corresponding indication on the instrument
cluster.
NOTE
•
If the user approaches the car within 3 s
after the intelligent active lock is activated,
the system will not activate the intelligent
active unlock but will consider that the user
wants to confirm whether the car is locked.
The user can confirm whether the doors
are locked by pulling the rear door handles.
It should be noted that the intelligent active lock
function will not be activated in case of the
followings:
– The power mode is in any mode other than
"OFF".
– The battery voltage is low.
– The intelligent remote control key is in the car.
– No intelligent remote control key is detected
within 2 m of the car.
– One of the doors is ajar.
–
The intelligent remote control key is thrown
into the car from the door window.
–
The intelligent remote control key is in the
trunk.
– The intelligent remote control key is too close
to the car.
NOTE
•
The intelligent active lock function cannot
automatically close the door windows and
the sunroof, so before leaving the car,
make sure that all door windows and the
sunroof are closed.
•
Do not leave children or handicapped
persons in the ca
intelligent active lock function.
4. Operation of Systems and Equipment
To Next Page
Loading...
