Anti-pinch function of sunroof
The
anti-pinch function is available for the closing
of the sunroof:
– When the sunroof is closed by sliding, if the
anti-
pinch function is activated, the sunroof
will move in the opening direction for a certain
distance and then stop.
–
When the sunroof is closed by tilting, if the
anti-
pinch function is activated, the sunroof
will move in the tilting direction until it reaches
the maximum tilting position.
NOTE
Do not operate the sunroof when the ambient
temperature is below -20°C, at which the anti-
pinch function of the sunroof may not be
activated, resulting in accidents. In addition, the
low temperature will also damage the motor to a
certain extent.
WARNING
• The anti-
pinch function of the sunroof
cannot prevent pinching of light or thin
objects.
•
When closing the sunroof, make sure
that no one is within the movement
range of the sunroof to avoid any
pinching.
•
The sunroof will stop detecting
obstacles at a position where the
sunroof is about to be closed fully, so
the anti-
deactivated at this time.
• Do not try to activate the anti-pinch
function by your hand or any part of
your body, otherwise there will be a risk
of pinching.
Manual initialization and self-
sunroof
Ordinary sunroof*
–
When the sunroof is tilted, if you press the
button on the sunroof switch ① upward
and hold it for more than 10 s, the sunroof will
start to be initialized.
– If you press the
switch ①
upward and hold it (or push the
sunroof switch ①
forward and hold it), the
sunroof will be “closed by tilting → opened by
sliding → closed fully” and then will stop, thus
completing the self-learning.
4. Operation of Systems and Equipment
To Next Page
Loading...
