Hazard warning lamp
When the engine start/stop button is in any
position, if you press the switch , the switch red
indicator lamp will flash and the hazard warning
lamp will be turned on.Press this switch again to
turn off the hazard warning lamp.
If the hazard warning lamp is turned on, all turn
signal lamps and the indicator lamps
and
on the instrument cluster will flash simultaneously.
The hazard warning lamp shall be turned on in the
following cases so as to attract the attention of
persons on the road and reduce the risk of traffic
accidents:
– The car is involved in any failure.
– The car is at the tail end of a traffic jam.
– The car tows another car or is towed.
–
The car is temporarily parked due to poor
visibility.
NOTE
• The use
of the hazard warning lamp will
consume the battery power, so please turn
it off when not in use.
•
Be sure to strictly abide by the relevant
regulations when using the hazard warning
lamp.
• In the event of an emergency, if the hazard
warning lamp is faulty, other methods that
comply with the relevant traffic rules and
regulations must be taken to attract the
attention of persons on the road.
Emergency brake warning lamp
– When the car is traveling at a high speed and
the emergency brake is applied, the brake
lamps will come on and the turn signal lamps
will flash.
Car assisted lighting
– If you press the unlock button
remote control key within the effective range,
the position lamps will stay on for 25 s for the
purpose of helping you to approach your car.If
you press the unlock button
on the remote
control key again, the position lamps can stay
on for another 25 s.When the engine
start/stop button is switched to the "ON"
position, the position lamps will go out.
Car locating lighting
– If you press the lock button
on the remote
control key twice within 0.5 s, the position
lamps will stay on for 8 s and the turn signal
lamps will flash 3 times for the purpose of
helping you to locate your car.
4. Operation of Systems and Equipment
To Next Page
Loading...
