– Turn the knob ⑦ up/down to adjust the wiper
sensitivity, that is, turning up can increase the
sensitivity, and turning down can decrease it.
NOTE
•
If the instrument cluster displays "Sensor
Failure, Please Manually Control Wiper",
for the sake of safety, you should manually
control the wiper and go to the GAC Motor
authorized shop for inspection in time.
•
Before activating the automatic wiping
function in winter, please check whether
the wiper blade is frozen.
•
It is recommended to deactivate the
automatic wiping function when cleaning
the car, in dusty weather and in rainless
weather to avoid unintentional wiping of the
wipers which may cause damage or
personal injury.
• The automatic wiping function is an assist,
so the driver should manually operate the
wipers when necessary according to the
driving situation to ensure driving safety.
INT: intermittent wiping*
–
If the wiper combination switch is turned to
the ③ INT position, the front wiper will start
wiping intermittently.
– For the models equipped with the automatic
wiping function, this function can be activated
by setting the AV system "System Settings →
Body Accessories → Other Accessories →
Auto Wiping".
– Turn the knob ⑦
intermittent wiping speed, that is, turning up
can increase the speed, and turning down
can decrease it.
LO: slow speed wiping
–
If the wiper combination switch is turned to
the ④ LO position, the front wiper will wipe
at a slow speed.
HI: high speed wiping
–
If the wiper combination switch is turned to
the ⑤ HI position, the front wiper will wipe at
a high speed.
Front windshield washer system on
–
If the wiper combination switch is turned
toward the rear of the car to the ⑥ position,
the front washer will start spraying water and
then the front wiper will start wiping.
– If the wiper combination switch is released to
return to its original position, the front
windshield washer system will be stopped
and the front wiper will wipe twice.
– After the front wiper stops wiping for 6 s, it will
wipe once again so as to clear the residual
water stains from the glass.
Wiper maintenance
–
Within 10 s after switching the engine
start/stop button to the "OFF" position, if you
turn the control lever of the wiper combination
switch to the MIST position and then quickly
release it to return it to the original position,
the front wiper will move to the highest
position and then stop.
NOTE
This function can be activated or deactivated by
setting the AV system "System Settings → Body
Accessories → Other Accessories → Wiper
Maintenance".
4. Operation of Systems and Equipment
To Next Page
Loading...
