MIC TRAC Operation Manual Model MT-3000
Copyright © 2014 Gagemaker. All rights reserved
11
Digital Readout (DRO) Rear Panel
The rear panel contains receptacles for plugging in the various cords that come with the MIC TRAC.
Power Switch
The power switch turns the DRO on. Flip
the switch to power up the unit.
Power Connection with Fuse
The power connection accepts the power
cord. The DRO requires 100-240VAC,
50/60Hz.
X2 – Load Cell Connector
This port is used to with the MIC TRAC
models that have the Force-Lok option.
The 9-pin connector extending from the
base unit connects to this port.
Plug the connector in and secure it in
place with the screws.
X1 – Scale Connector
The X1 port connects to the internal
scale of the MIC TRAC.
Plug the 15-pin plug from the base unit
into this port.
To Next Page
Loading...
Need help?
General
