MIC TRAC Operation Manual Model MT-3000
Copyright © 2014 Gagemaker. All rights reserved
7
Returning the MIC TRAC
1. Contact Gagemaker for a Return Authorization Number at 713-472-7360.
No shipments will be accepted without a Return Authorization Number.
2. If you have removed the lifting lugs, reattach them before shipping the unit back to the factory.
3. Tighten the coarse adjust and fine adjust locks before packing the unit.
4. Place two 36" X ¾" durable lifting straps around the lifting lugs and place the unit in the original
shipping carton. The lifting lugs will fit into the grooves in the bottom of the carton.
If the unit is returned in any container other than the original shipping carton, there will be a
charge for carton replacement when the gage is returned to you. Gagemaker is not
responsible for any damages incurred during return shipment due to poor packing.
5. Place the wood strips over the bolts in the shipping carton.
6. Place the washers and wing nuts over the boards and tighten.
7. Close the lid and secure the flap to the velcro on the side of the carton.
8. Secure the three strap latches on the outside of the shipping carton.
9. Secure the shipping carton to a pallet.
10. Display the Return Authorization Number clearly on the shipping carton.
11. Ship to the following address by motor freight only. UPS shipments will not be accepted.
Gagemaker
712 East Southmore Ave.
Pasadena, Texas 77502
MIC TRAC Secured in Original Shipping Carton
To Next Page
Loading...
Need help?
General
