Gaggia Anima - Page 37

GAGGIA ANIMA 05 TROUBLESHOOTING
Pag. 6/9
Press and Release the Z4 button to switch on the pump (100
Press and Release the Z4 button to switch on the pump (100
impulses)
impulses)
The water goes out from the pipe and the indication
The water goes out from the pipe and the indication
IMP
IMP
shows
shows
increasing numbers. The indication L/H must be within the range
increasing numbers. The indication L/H must be within the range
10-18.
10-18.
ERROR:
ERROR:
The display backlight changes from white to red and the
The display backlight changes from white to red and the
impulse remains 0; If water comes out the pipe: check the wiring
impulse remains 0; If water comes out the pipe: check the wiring
from the fl owmeter to the CPU/POWER board (JP5). If no water
from the fl owmeter to the CPU/POWER board (JP5). If no water
comes out the pipe: check the pump and the wiring from the pump
comes out the pipe: check the pump and the wiring from the pump
to the CPU/POWER board (JP24).
to the CPU/POWER board (JP24).
ERROR:
ERROR:
The L/H is zero or very low; the Electro Valve does not
The L/H is zero or very low; the Electro Valve does not
open. Check the wiring from the Electro Valve to the CPU/POWER
open. Check the wiring from the Electro Valve to the CPU/POWER
board (JP3) and the Electro Valve.
board (JP3) and the Electro Valve.
The machine passes to the level 5 (Heater-Grinder)
The machine passes to the level 5 (Heater-Grinder)
It is possible to hear the “click” from Electro Valve. The indication
It is possible to hear the “click” from Electro Valve. The indication
beside the
beside the
EV1
EV1
changes from “OFF” to “ON”.
changes from “OFF” to “ON”.
Press
Press
Z7
Z7
“
“
” to move to the next screen
” to move to the next screen
Press the Z4 button to switch on the grinder.
Press the Z4 button to switch on the grinder.
The grinder rotates and in the indication
The grinder rotates and in the indication
GRINDER
GRINDER
the number
the number
increasing up to 5000 (5seconds test). The other numbers inside the
increasing up to 5000 (5seconds test). The other numbers inside the
GRINDER
GRINDER
box are not important for this test.
box are not important for this test.
ERROR:
ERROR:
The number remains 0 or the grinder does not run, the
The number remains 0 or the grinder does not run, the
display backlight changes from white to red; check the Grinder and
display backlight changes from white to red; check the Grinder and
the wiring from the Grinder to the CPU/POWER board (JP8)
the wiring from the Grinder to the CPU/POWER board (JP8)
Check the temperature
Check the temperature
The number shows the heater temperature.
ERROR:
ERROR:
In the indication
In the indication
HEATER
HEATER
appears
appears
“SHORT”
“SHORT”
, the
, the
NTC
NTC
temperature-sensor is shorted, the display backlight changes from
temperature-sensor is shorted, the display backlight changes from
white to red; check the wiring from the NTC temperature-sensor to
white to red; check the wiring from the NTC temperature-sensor to
the CPU/POWER board (JP13).
the CPU/POWER board (JP13).