GAGGIA ANIMA 05 TROUBLESHOOTING
Pag. 5/9
The absorbed current is more than 300mA,
The absorbed current is more than 300mA,
the display backlight changes from white to red; check the BU and
the display backlight changes from white to red; check the BU and
Press the Z3 button to move the BU to Home
Press the Z3 button to move the BU to Home
When the BU reaches the home position the indication HOME
changes from “N” to “Y”, the number of the current is minus than
200mA (without BU) or 300mA (with BU).
doesn’t change and remain “N”,
doesn’t change and remain “N”,
the display backlight changes from white to red; Check the work
the display backlight changes from white to red; Check the work
microswitch (is broken), the BU motor (is blocked) and the wiring
microswitch (is broken), the BU motor (is blocked) and the wiring
The absorbed current is higher than
The absorbed current is higher than
200mA, the display backlight changes from white to red; check the
200mA, the display backlight changes from white to red; check the
The absorbed current is higher than 300mA,
The absorbed current is higher than 300mA,
the display backlight changes from white to red; check the BU and
the display backlight changes from white to red; check the BU and
” to move to the next screen
” to move to the next screen
Press the Z1 button to open the Electro Valve
Press the Z1 button to open the Electro Valve
IMPORTANT NOTE: If the DREGDRAWER is not inserted or the
DOOR is not closed the EV test cannot be performed. If these 2
inputs are not in the right position, a warning message will be
shown and the display turns to red.
The machine passes to the Page 4
The machine passes to the Page 4
To Next Page
Loading...
