Configuration
14 · G&D DVIVision
Changing the configuration
The configuration can either be changed in the setup mode or in the setup menu.
The descriptions of the configurable functions on the following pages include ins
-
tructions on how to configurate both the setup mode and the setup menu.
Using the setup mode
The setup mode can be activated through the keyboard of a console at any time.
After the setup mode has been activated, the configuration of the DVIVision system
can be changed with various setup keys.
How to activate the setup mode:
Press the key combination Hotkey + Backspace (default: Ctrl + Backspace) at the
same time to activate the setup mode.
The control LEDs NUM,
and Scroll are blinking simultaneously if the setup mode
has been successfully activated. Additionally, the yellow user LED at both the com
-
puter module and the user module is blinking.
Now you can perfom a setup function.
How to perform a setup function:
After the setup mode has been activated, press one of the setup keys that are
described on the following pages.
How to end the setup mode without performing a function:
Press ESC to end the setup mode.
After the call of the setup mode, only one setup function can be carried out. If you
want to perform several functions, you have to restart the setup mode after having
performed a function.
In the default settings, the key combination to activate the setup mode has to be
pressed for seven seconds.
After the first call of the setup mode, the hotkey delay can be turned off by pres-
sing the setup key 8 (see page 17).
To Next Page
Loading...
