Configuration
G&D DVIVision · 29
Activating or resetting a PS/2 mouse
Unlike USB mouse devices, PS/2 mouse devices do not support the hot plug tech-
nology. You can therefore insert the PS/2 plug during operation but it may be pos-
sible that the computer does not detect the input device.
To activate or reset the PS/2 mouse, a special command can be send to the compu-
ter through the DVIVision system.
Since the commands differ depending on the used mouse type and the installed ope-
rating system, four different setup keys are provided.
How to activate or reset a PS/2 mouse:
A PS/2 mouse can only be activated or reset in the setup mode.
setup mode
1. Press the key combination Hotkey + Backspace (default: Ctrl + Backspace) to
activate the setup mode. If the hotkey delay is active, press the key combi
-
nation for seven seconds.
2. Press one of the following setup keys to activate or reset the PS/2 mouse:
M activates the PS/2 mouse of a Linux computer
I activates the PS/2 wheel mouse of a Linux computer
E activates the PS/2 wheel mouse with additional keys of a Linux computer
R resets the PS/2 mouse interface of a Windows computer
To Next Page
Loading...
