G&D DVIVision - Using the Setup Menu

Configuration
G&D DVIVision · 15
Using the setup menu
The setup menu enables you to comfortably view and edit the configuration of the
DVIVision system. In contrast to the setup mode, it is possible to edit several set
-
tings within one session.
For using the setup menu, start any terminal emulation program on a computer (for
example HyperTerminal or PuTTY). The computer on which the terminal emulation
program is installed, is connected to the Service socket of the computer module or the
user module with supplied data cable.
How to establish a connection in the terminal emulation program:
 Start any terminal emulation program (for example HyperTerminal or PuTTY).
 Collect the following data to establish a connection to the DVIVision system:
 Bits per second: 38400
 Data bits: 8
 Parity: None
 Stop bits: 1
 Flow control: None
 Use the supplied data cable to connect the computer to the Service socket on the front
panel of the computer module or the user module.
How to start the setup menu:
 Start the terminal emulation program.
 Load the connection settings of the setup menu and establish the connection.
 Press the Enter key in the terminal emulation program.
As soon as the connection has been succesfully established, the setup menu is dis-
played within the terminal emulation program (see figure on page 16).
How to end the setup menu:
 Press the key combination Ctrl + x twice to end the setup menu.