Configuration
G&D DVIVision · 31
Resetting the default settings
This function resets the default settings of the DVIVision system. By performing this
function, the default settings of the DVIVision system mentioned on
page 13 are
reactivated.
How to reset the default settings:
setup mode
1. Press the key combination Hotkey + Backspace (default: Ctrl + Backspace) to
activate the setup mode. If the hotkey delay is active, press the key combi
-
nation for seven seconds.
2. Press the setup key listed below to reset the default settings:
D resets the default settings
setup menu
1. Establish the connection to the DVIVision through the terminal emulation
program.
2. Use the arrow keys to select the row Set System Defaults.
3. Press the Enter key to reset the default settings.
4. Confirm the now appearing security query with the Enter key. You can can-
cel the function by pressing the Q key.
To Next Page
Loading...
