G&D DVIVision - Changing the Single Hotkey

Configuration
G&D DVIVision · 19
Changing the single hotkey
The hotkey has to be pressed in combination with the Backspace key to call the setup
mode of the DVIVision system.
If an application program or another G&D device within the cascade uses the same
hotkey, the hotkey can be changed.
How to change the current hotkey:
Related topic:
 Using single or double hotkeys on page 18
The single hotkey Ctrl is preset in the delivery status.
setup mode
1. Press the key combination Hotkey + Backspace (default: Ctrl + Backspace) to
activate the setup mode. If the hotkey delay is active, press the key combi
-
nation for seven seconds.
2. Press one of the setup keys listed below to activate a certain hotkey:
Ctrl  activates the hotkey Ctrl
Alt  activates the hotkey Alt
Alt Gr  activates the hotkey Alt Gr
Win  activates the hotkey Win
Shift  activates the hotkey Shift
setup menu
1. Establish the connection to the DVIVision system through the terminal
emulation program.
2. Use the arrow keys to select the row Hotkey.
3. Press the Space key (repeatedly) to activate a certain hotkey:
Ctrl  activates the hotkey Ctrl
Alt  activates the hotkey Alt
Alt Gr  activates the hotkey Alt Gr
Win  activates the hotkey Win
Shift  activates the hotkey Shift
4. Press the S key to save the settings.