G&D DVIVision - Changing the Double Hotkey

Configuration
20 · G&D DVIVision
Changing the double hotkey
If you have activated the use of double hotkeys (see page 18), the double hotkey has
to be pressed in combination with the Backspace key to call the setup mode of the
DVIVision system.
The double hotkey can be changed if an application program or another G&D
device within the cascade uses the same double hotkey.
How to change the current double hotkey:
Related topic:
 Using single or double hotkeys on page 18
setup mode
1. Requirement: activation of the double hotkeys (see page 18).
2. Press the key combination Hotkey + Backspace (default: Ctrl + Backspace) to
activate the setup mode. If the hotkey delay is active, press the key combi
-
nation for seven seconds.
3. Press one of the setup keys listed below to activate the desired double hotkey:
Ctrl  activates the double hotkey Ctrl + Shift
Alt  activates the double hotkey Alt + Shift
Alt Gr  activates the double hotkey Alt Gr + Ctrl
Win  activates the double hotkey Win + Ctrl
Shift  activates the double hotkey Shift + Win
setup menu
1. Requirement: activation of the double hotkeys (see page 18).
2. Establish the connection to the DVIVision system through the terminal
emulation program.
3. Use the arrow keys to select the row Hotkey.
4. Press the Space key (repeatedly) to activate the desired double hotkey:
Ctrl + Shift  activates the double hotkey Ctrl + Shift
Alt + Shift  activates the double hotkey Alt + Shift
Alt Gr + Ctrl  activates the double hotkey Alt Gr + Ctrl
Win + Ctrl  activates the double hotkey Win + Ctrl
Shift + Win  activates the double hotkey Shift + Win
5. Press the S key to save the settings.