GARDTEC 816 - Programming Linefault Modes

Page 123
Programming Linefault Modes
1) Enter into Engineer Mode
To do this follow Steps 1 to 4 on page 79
With the display showing:-
2) Press No six times. The display will show:-
3) Press Yes. The display will show:-
4) Press Yes. The display will show:-
5) Press No until the required setting is displayed
then press Yes. The display will show:-
6) Press No. The display will show:-
7) Press Yes. The display will show:-
8) Press No until the display shows the required
setting, then press Yes. The display will show:-
Program . . . . _ _ _
Zones ?
Program . . . . _ _ _
Linefault Modes ?
Program Linefault
Sounders ?
Linefault Sounders
= ON if Un-Set
Program Linefault
Sounders ?
Program Lineflt
Mode in Exit ?
Program Lineflt
Mode in Exit ?
Lineflt Mode . . .
= Detect in Exit
PR5892 Rev11 800 Series Eng Ref 15.qxd 16/11/2006 11:21 Page 123