32 Astro Dog Tracking System Owner’s Manual
GPS Applications
Compass Page Options
Use the options menu to customize the Compass page.
With the Compass page open, press MENU. To select an
option, highlight it, and press ENTER.
The following options are available:
Sight ‘N Go—allows you to navigate to an object
within your sight by pointing the unit at it.
Stop or Resume Navigation—turns active navigation
for a route or a Go To on or off.
Recalculate—recalculates the path to a destination.
Course or Bearing Pointer—auto routes between the
course pointer and the bearing pointer.
Data Fields—allows you to select from 2, 3 or 4 data
elds that appear on the Compass page.
Change Data Fields—allows you to select the type of
data you want to show in the data elds.
•
•
•
•
•
•
Calibrate Compass—accesses the Compass
Calibration page for calibrating the compass.
Restore Defaults—returns to the factory settings.
Sight ‘N Go Navigation
Sight ‘N Go allows you to set a course to a point you can
see in the distance.
To use Sight ‘N Go to navigate:
1. Press MENU > select Sight ‘N Go > to start the Sight
‘N Go feature. The compass ring with pointer is in line
with the two sighting marks on the case (the top arrow
of the ROCKER and tic mark at the top of display
bezel).
2. Hold the unit at eye level and line up the two sighting
marks with the distant object.
3. Press ENTER to lock the direction and open the
Sighting page.
•
•
To Next Page
Loading...
