GPSMAP 60CSx Owner’s Manual 49
MAIN PAGES >
The compass ring is an electronic compass that
functions like a magnetic compass when you are
stationary. When you are moving and reach a pre-set
speed, it uses data from the GPS receiver to maintain
your heading. When you stop (after a pre-set time), it
again operates like a magnetic compass. The compass
ring is especially helpful when using a paper map
or chart with your GPSMAP 60CSx for navigation.
When the electronic compass is on, a compass icon
appears in the status bar.
Using the Electronic Compass
When you turn the electronic compass off, it stays off
until you turn it on again. However, sometimes when
you turn the electronic compass on, the GPSmap
60CSx overrides the compass and uses the GPS
receiver to track your heading. In fact, when you are
moving at a steady rate, the GPS receiver operates
the compass. When stationary, the electronic compass
is active to provide you accurate headings. You can
customize the criteria for switching between the
electronic compass and the GPS as explained in the
Heading setup section on page 75.
To turn the electronic compass on or off:
1. Press and hold the PAGE key to turn the
electronic compass on or off. The Compass
Icon appears in the status bar when the
electronic compass is on. When you are not
using the electronic compass, turn it off to
conserve batteries. When it is turned off, the
unit uses the GPS receiver for navigation.
2. Hold the GPSMAP 60CSx level to get an
accurate electronic compass reading. You
can obtain the most accurate reading if it
is calibrated. (See the following page for
calibration instructions.)
Setting the speed and time for Compass
Auto On/Off:
1. Press MENU twice to open the Main Menu.
2. Highlight Setup, and press ENTER to open
the Setup Menu.
3. Highlight the Heading icon, and press ENTER
to open the Heading Setup Page.
4. Highlight the Switch to compass heading
when below field, and press ENTER.
To Next Page
Loading...
