Garmin MX20 - Special Tools Required; License Requirements; Operating Instructions

Introduction
6 560-1025-09 Rev E MX20 Installation Manual
1.6 Special Tools Required
Crimp Tool
A crimp tool meeting MIL specification M22520/1-01 and a positioner/locator are required to ensure
consistent, reliable crimp contact connections for the rear d-sub connectors. Examples of these tools are
shown below:
For pin P/N 245-0027
ITT Cannon Phone 714 261 5300
1851 E. Deere Ave. Fax 714 575 8324
Santa Ana, CA 92705-6500
Insertion tool: ITT part # 274-7006-000 (Desc. CIET-20HD)
Regular-duty Crimp tool: ITT part # 995-0001-585 (Desc. M22520/1-01)
Regular-duty Locator tool: ITT part # 995-0001-244 (Desc. TH25)
Heavy-duty Crimp tool: ITT part # 995-0001-584 (Desc. M22520/2-01)
Heavy-duty Locator tool: ITT part # 995-0001-604 (Desc. M22520/2-08)
For pin P/N 245-0059 (High Density Connector – I/O Only)
Astro Tool Corp Phone 503 642 9853
21615 SW TV Highway Fax 503 591 7766
Beaverton, OR 97006
Crimp tool: Astro Tool part # 615708
Positioner: Astro Tool part # 616356
1.7 License Requirements
There are no license requirements for the MX20.
1.8 Operating Instructions
The MX20 Pilot’s Guide, Garmin AT P/N 560-1026-( ), covers operation and pilot interface. The MX20
Quick Reference Guide is P/N 561-0263-( ).