BURST (gen.2*)
12
WWW.GATEE.EU
USER GUIDE
ROF CONTROL
ROF STAB
SMART TRIGGER
SNIPER DELAY
The burst enables you to shoot a pre-determined number of BBs, which is very useful in
MILSLIM and when using low-caps. The BURST mode is available after setting the proper
fire selector mode. There are two BURST modes:
• FULL – every, even the shortest trigger action fires the pre-determined number of
rounds,
• TRIG – releasing the trigger while firing stops the burst sequence.
* There is no need to set burst time. You can easily set burst between two and 10 shots.
This enables a reduction in a gun's rate of fire. You use stronger LiPo batteries, and still
have a ROF just like in a real gun.
It allows you to change the way the ROF Control works:
ON - ROF Control uses PWM to decrease ROF. Thanks to this gearbox works smoothly
what decreases wear and tear of AEG internal parts.
OFF - ROF Control adds breaks between shots to decrease ROF. It gives you more realistic
experience.
It lets you to set delay between each SEMI shots to simulate the delay from reload or recoil.
You can set 0.5s, 1s, 2s or 3s delay.
We know how vital the fast trigger response is during combat. This is why we have
developed the Smart Trigger function. It enables you to achieve a faster trigger response.
It works with the ROF Control System. During the first shot, the microprocessor sets the
ROF Control to 100%. After the first shot, it switches to a previously programmed value
(e.g. 50%). As a consequence, the first shot is fired at a full ROF, and subsequent shots at a
reduced ROF. The best results can be achieved by using a battery with a higher than
standard voltage. For example, if you use a 7.4V battery, you can replace it with 11.1V. In
this way, you will achieve a faster trigger response with the same rate of fire as with a
standard battery.
*Works only when ROF STAB is ON.
To Next Page
Loading...
Need help?
General
