AUG MODE
13
WWW.GATEE.EU
USER GUIDE
BATTERY PROTECTION (gen.2*)
LOW BATTERY WARNING
SMART FUSE
ADAPTIVE ACTIVE BRAKE
MOSFET
Enjoy two stage trigger. Activate AUG Mode and set two different trigger sensitivities.
Pulling the trigger slightly produces SEMI or BURST fire and pulling the trigger further
produces BURST or AUTO fire (depending on the fire selector mode).
Protection against Over-Discharge of the Battery. Modern LiPo and LiFe batteries are very
sensitive to over-discharge. If you do not want to damage the battery and you care about
its service life, this protection is indispensable. The microprocessor monitors the battery
voltage constantly. When the voltage drops down to a critical level, it will not allow firing.
*TITAN detects the number of cells automatically. There is no need to reprogram TITAN every
time you replace the battery.
When the battery cells' voltage drops to a predefined level, the motor will vibrate at
regular intervals.
We have developed an electronic fuse with an accurate current sensor. A combination of
current, voltage and temperature measurements makes your AEG installation highly
reliable. It protects the MOSFET against overheating, overloading and short-circuiting. If
your airsoft gun becomes jammed, the function protects the motor and battery against
damage.
It automatically adjusts the motor's braking power according to your needs. This prolongs
the lifespan of the motor.
Do you want to achieve a higher ROF and faster trigger response? Are you planning a
power upgrade of your gun? In that case, you need a MOSFET.
It targets the energy from the battery directly to the motor, bypassing the mechanical
trigger contacts. As a result, you gain a higher ROF of the gun and a faster trigger
To Next Page
Loading...
Need help?
General
