84
OPERATION:
Switch on the air compressor unit and make sure that the airflow regulator on the air assist valve is opened
(turn clockwise to increase the airflow, counter-clockwise to decrease the airflow). The air nozzle under the
laser head should emit a steady flow of air.
With the SmartAIR nozzle and air compressor properly installed and operating, all configurations and
settings relating to air-assist functions are controlled through the LaserPro print driver and hardware
control panel. Please refer to the LaserPro E200 PEN page on print driver section of this manual for
details on how to enable and configure air-assist functionality.
To Next Page
Loading...
