Operating instructions
QS4 Technical Reference Manual 3.9
Tasks that require you to log on as a Level 3 operator
What is it you want to do This is how you do it
Disable or enable an And Group,
Matrix Group, or Time Control
1. Press Menu.
2. Choose Disable or Enable.
3. Choose And if an And group, Matrix if a Matrix group, or
Time Control if a time control.
4. Pick a group from the appropriate list and press Enter.
Disable or enable a switch on a zone
display
1. Press Menu.
2. Choose Disable > Switch.
— or —
Enable > Switch.
3. Enter the switch address, where GG is the group number,
and SS is the switch number.
Disable or enable the mapping
function on an SLIC
1. Press Menu.
2. Choose Disable > Loop Mapping.
— or —
Enable > Loop Mapping.
3. Enter the card address for the SLIC.
Start a Service Group test
1. Press Menu.
2. Choose Test > Start Test.
3. Select a Service group from the pick list and press Enter.
Cancel a Service Group test
Note: The panel automatically resets
after you cancel a test.
1. Press Menu.
2. Choose Test > Cancel Test.
2. Select a Service group from the pick list and press Enter.
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...