Ge Est QS4 - Quickreference List

Operating instructions
QS4 Technical Reference Manual 3.11
QuickReference list
Required access level
What is it you want to do L1 L2 L3 L4
Change smoke detector sensitivity settings to their alternate values
üüü
Change smoke detector sensitivity settings to their primary values
üüü
Change the current state of an LED (manual override)
üü
Change the current state of an output circuit (manual override)
üü
Change the password required for Level 1 access
üüü
Change the password required for Level 2 access
üü
Change the password required for Level 3 access
ü
Change the password required for Level 4 access
ü
Disable or enable a device
üüü
Disable or enable a switch on a zone display
üü
Disable or enable a zone
üüü
Disable or enable all the devices on a single card
ü
Disable or enable an And Group, Matrix Group, or Time Control
üü
Disable or enable the mapping function on an SLIC
üü
Get a list of all the active points on a panel
üüüü
Get a list of all the hardware and software components installed on a
panel and their revision levels
üü
Get a list of smoke detectors that may require servicing (DIRTY attribute
greater than 20%)
üüüü
Get a list of smoke detectors that require servicing (DIRTY attribute
greater than 80%)
üüüü
Get the attributes for a single smoke detector
üüüü
Get the attributes for all the smoke detectors on a single SLIC
üüüü
Identify output devices that are turned on
üüüü
Identify active points in a Service Group that is being tested
üüüü
Identify points that are disabled
üüüü
Identify points that are in their active state
üüüü
Identify points that are in trouble
üüüü
Log onto the panel as a Level 2 operator
üüü
Log onto the panel as a Level 3 operator
üü
Log onto the panel as a Level 4 operator
ü
Perform a lamp test
üüüü
Technical Manuals Online! - http://www.tech-man.com